RAYATTACHMENTS Multi Quick Coupler is suitable for the excavator rapid installation, switching various attachments (bucket, ripper, hydraulic breaker, hydraulic shear, etc.). It can enlarge the scope of use of the
excavator, and can save time and improve efficiency.
Double Lock：Rear Lock and Front Lock
1. Front safety lock retains the attachment in case of misconnection.
The rear safety lock retains the attachments in a working position in the
event of power loss.
2. Ray use “curl to release” control system guarantees the attachments is only
released in a safe position Powerful spring activated
3. safety lock works in all dirty environments unlike gravity systems.
4. Compliant with ALL current and proposed AS4772-2008 safety regulations
as well as WorkCover NSW Position Paper.
1.Our sample design has no greasing requirements, less maintenance and replacement parts which guarantee
you a hassle free coupler.
2.Manufactured using extra high strength steel to increase durability while optimizing weight to enhance
Variable pin centre design allows you to easily pick up and swap the widest range of OEM attachments.
Ability to reverse buckets to allow the operator to excavate against walls and under pipes.
Operator can change attachment from the comfort and security of their cab.
Before attaching, ensure safety lock is open with quick-hitch switch
(located inside cab) in off position, ensure slide is fully extended with front jaw safety lock open.
Line up attachment and engage front attachment pin.
Stroking the pump method
Active the quick-hitch switch on
Crowd Multi-Coupler this will charge the quick hitch lines to retract the slide mechanism
and this will visibly lock the front jaw safety latch around front attachment pin
Turn quick hitch switch off
Dump or crowed multi-coupler this will cause the sliding mechanism to extend and engoge
the rear slide hook onto rear attachment pin.
Proceed with connection test.
|RAY Multi Coupler Specification|
|Arm width |
|Safty:||RAY Multi Coupler Auto Dual-Lock Mechanism meets Australian and New Zealand Standard AS4772-2008.|
|Lifting eye:||Lifting mechanism is closed and arranged so that addidental unhooking for|
|load cannot occur.|